Performance & Quality Testing
Every Aquafarer inflatable boat and SUP undergoes rigorous performance and quality testing at our R&D Center before it ships. Eight protocols, zero sampling — every unit verified.
Testing Procedures
Rigorous Testing at Every Stage
Each test follows documented internal protocols aligned with international standards. Test results are recorded, traceable, and reviewed by our independent quality lab.
Pressure Testing
ISO 6185-1 | Internal Spec AF-PT-001Inflatable chambers are pressurized to 1.5x the recommended operating limit and held for 30 minutes. Pressure decay is measured to validate airtightness and structural integrity of materials and seams.
Impact Testing
Internal Spec AF-IT-002Products are subjected to controlled impacts from standardized drop weights and pendulum apparatus. This assesses puncture resistance, tear propagation, and structural resilience against collisions with obstacles, docks, and debris.
UV Resistance Testing
ASTM G154 | ISO 4892-3Material samples are exposed to UVA-340 lamps in accelerated weathering chambers for 1,000+ hours. We measure color change (Delta E), gloss retention, and tensile strength loss to validate UV stabilizer packages.
Abrasion Resistance Testing
ASTM D751 (Taber) | ISO 5470-1Material samples are subjected to CS-10 abrasive wheels under 500g/1,000g loads for 1,000 cycles. Mass loss and visual wear grading determine coating durability against sand, gravel, and repeated launching.
Low-Temperature Performance Testing
Internal Spec AF-LT-003 | MIL-STD-810GAssembled products and material coupons are conditioned at -20°C, -10°C, and 0°C for 24 hours then flex-tested. We verify that PVC and Hypalon remain flexible without cracking or delamination.
Buoyancy & Load Capacity Testing
ISO 6185-1 | ISO 12402Products are incrementally loaded to 1.25x rated capacity in a controlled pool. Freeboard, stability, and self-draining performance are recorded. Every model's rated capacity is mathematically and empirically verified.
Maneuverability Testing
Internal Spec AF-MT-004On-water trials measure turning radius, acceleration, planing time, and paddle/motor response across a range of load conditions. Real-world handling characteristics are validated against design targets.
Watertightness Testing
ISO 6185-1 §7.3 | Internal Spec AF-WT-005Every assembled product is spray-tested at 0.5 bar on all seams, valves, and fittings. A 5-minute pressurized submersion test validates chamber and valve watertightness. Zero-leak standard before shipping.
“The level of documentation and traceability Aquafarer provides for quality testing exceeds what we've seen from Chinese manufacturers. Each shipment includes a full test report with standards references and pass/fail data.”
Marcus Hansen
Procurement Manager, Nordic Marine Supply · Sweden
Independent Quality Lab
Our quality lab operates independently from production and reports directly to management. No batch is shipped without signed quality release.
See our trust certifications →Our Commitment
Through these rigorous testing procedures, Aquafarer provides customers with the assurance that our inflatable SUPs and boats are not only high-performing but also built to last —ensuring countless enjoyable and safe adventures on the water. Our quality lab operates independently from production and reports directly to management.